PT - JOURNAL ARTICLE AU - Lensky, Yuri D. AU - Mazenc, Edward A. AU - Ranard, Daniel AU - Vilim, Matthew AU - Prakash, Manu AU - Brooks, Bill AU - Bradley, Amanda AU - Engelschenschilt, Alain AU - Plutz, Jason AU - Zellmer, Todd TI - Heat-based Decontamination of N95 Masks Using a Commercial Laundry Dryer AID - 10.1101/2020.07.22.20160283 DP - 2020 Jan 01 TA - medRxiv PG - 2020.07.22.20160283 4099 - http://medrxiv.org/content/early/2020/07/24/2020.07.22.20160283.short 4100 - http://medrxiv.org/content/early/2020/07/24/2020.07.22.20160283.full AB - We propose a dry heat method for decontaminating N95 masks of SARS-CoV-2, designed around placing them in resealable plastic bags, packed in large cardboard boxes installed at the rear end of commercial laundry dryers. Our protocol rests on data collected in collaboration with Alliance Laundry Systems (ALS) and the CDC/NIOSH laboratories, under the “NPPTL Respirator Assessments to Support the COVID-19 Response” initiative. We test the two most widely available ALS tumbler models, the UTF75N and UT075N, and show that if our procedure is carefully followed, the masks will be subject to suitably high and stable temperatures for decontamination; in particular the masks will be heated to at least 80 °C for at least 65 min. For the mask models 3M 1860, 3M 8511, and Halyard 62126, we establish that they pass quantitative fit tests and retain sufficient filtration performance after three cycles of our decontamination procedure. All masks used in this study were new and uncontaminated: the evidence for the levels of biological inactivation of SARS-CoV-2 is provided by [1]. While the protocol outlined here is currently specific to certain tested dryer models, this equipment is widely available, with machines estimated to be within 15 minutes of most US hospitals. Models from other manufacturers may also be appropriate for this decontamination method, though we stress the need for explicit testing on alternative models before use.Competing Interest StatementAuthors Bill Brooks, Amanda Bradley, Alain Engelschenschilt, Jason Plutz and Todd Zellmer are employed by Alliance Laundry Systems, the company whose dryers were characterized in this work.Funding StatementYuri Lensky is supported by the Hertz Foundation. No payment for this work was provided by a third party. New masks to be tested as part of this work were supplied by Medline Industries.Author DeclarationsI confirm all relevant ethical guidelines have been followed, and any necessary IRB and/or ethics committee approvals have been obtained.YesThe details of the IRB/oversight body that provided approval or exemption for the research described are given below:NoneAll necessary patient/participant consent has been obtained and the appropriate institutional forms have been archived.YesI understand that all clinical trials and any other prospective interventional studies must be registered with an ICMJE-approved registry, such as ClinicalTrials.gov. I confirm that any such study reported in the manuscript has been registered and the trial registration ID is provided (note: if posting a prospective study registered retrospectively, please provide a statement in the trial ID field explaining why the study was not registered in advance).YesI have followed all appropriate research reporting guidelines and uploaded the relevant EQUATOR Network research reporting checklist(s) and other pertinent material as supplementary files, if applicable.YesRaw data of temperature sensor logs used in this paper can be obtained by emailing ydl{at}stanford.edu. All other data is presented in the main text or appendices.